Timing transponder mount

Just back from a practice day down at wollongong. Very succesful :) knocked 1.5 seconds off my best time down to 36.4 which is mixing it up with the back markers. so couldnt be happier about that.

All the bikes worked well but it was a little annoying finding room for the timing transponder. they are pretty big (relatively speaking compared to a pocket bike) so finding room for them so they wont get in the way is tricky. so i made a solid mount for them

A couple of other guys at the track use this setup and it works well so i did the same. Its a piece of 28x28 x 1mm wall aluminium box section with two 19mm slots milled in each side then the original brake caliper mounting holes hold it on and two m3 stainless bolts hold the plastic transponder holder in. works well! weight nothing. all good :)